diff options
Diffstat (limited to 'OpenSim/Region')
| -rw-r--r-- | OpenSim/Region/Physics/Meshing/Meshmerizer.cs | 7 |
1 files changed, 7 insertions, 0 deletions
diff --git a/OpenSim/Region/Physics/Meshing/Meshmerizer.cs b/OpenSim/Region/Physics/Meshing/Meshmerizer.cs index 161f4e1..b770d68 100644 --- a/OpenSim/Region/Physics/Meshing/Meshmerizer.cs +++ b/OpenSim/Region/Physics/Meshing/Meshmerizer.cs | |||
| @@ -1580,6 +1580,13 @@ namespace OpenSim.Region.Physics.Meshing | |||
| 1580 | Console.WriteLine("Sphere dimple: fProfileBeginAngle: " + fProfileBeginAngle.ToString() + " fProfileEndAngle: " + fProfileEndAngle.ToString()); | 1580 | Console.WriteLine("Sphere dimple: fProfileBeginAngle: " + fProfileBeginAngle.ToString() + " fProfileEndAngle: " + fProfileEndAngle.ToString()); |
| 1581 | #endif | 1581 | #endif |
| 1582 | } | 1582 | } |
| 1583 | else if ((primShape.ProfileCurve & 0x07) == (byte)ProfileShape.Square) | ||
| 1584 | { // tube cut is offset 45 degrees from other prim types | ||
| 1585 | fProfileBeginAngle += 45.0f; | ||
| 1586 | fProfileEndAngle += 45.0f; | ||
| 1587 | if (fProfileBeginAngle < fProfileEndAngle) | ||
| 1588 | fProfileEndAngle -= 360.0; | ||
| 1589 | } | ||
| 1583 | 1590 | ||
| 1584 | // Note, that we don't want to cut out a triangle, even if this is a | 1591 | // Note, that we don't want to cut out a triangle, even if this is a |
| 1585 | // good approximation for small cuts. Indeed we want to cut out an arc | 1592 | // good approximation for small cuts. Indeed we want to cut out an arc |