/ Sequence config for MLPV2.3 / lines beginning with slash are comments / Global commands (these are commented out) / Use any number of these by deleting the slash at the beginning / debug | 1 | sequence start/stop / debug | 2 | echo each command as executed / debug | 4 | avatar hop on/off / debug | -1 | all debugging / Sequence Commands: / ======= / SEQUENCE | seqence-name / MENU | menu-name | set number & colors of balls / POSE | pose-name | chat-chan | chat-message | start a pose (chan & message are optional; message is whispered). / AVWAIT | 0 1 2 3 | chat-message-if-waiting | pause the sequence until the balls listed are sat on (0 1 2 3 in this example) / SAY | chat-chan | chat-message | say the given text on the given chat chan / WHISPER | chat-chan | chat-message | whisper the given text on the given chat chan / WAIT | wait-seconds | pause before executing next command / LABEL | label-name | set a target for GOTO / GOTO | label-name | go to a label, to loop the bottom of a sequence / REPEAT | repeat the whole sequence / Chat-messages can include the first names of participants using /0 for avatar on first ball, /1 for av on 2nd ball, etc. / (See the names of the ball objects.) SEQUENCE | Tour1 MENU | Example... POSE | standing AVWAIT | 0 | Waiting for someone to sit on blue ball WHISPER | 0 | /0 and /1 stand together WAIT | 10 POSE | pillow-sit | 0 | /0 and /1 sit with a comfy pillow WAIT | 10 POSE | sit2 | 0 | The pillow disappears WAIT | 10 REPEAT SEQUENCE | tour2 MENU | Example... POSE | standing | 0 | The two of you stand WAIT | 10 LABEL | here POSE | pillow-sit | 0 | /0 and /1 sit with a pillow WAIT | 10 POSE | sit2 | 0 | Where did the pillow go? WAIT | 10 GOTO | here